Xtreme Stone Protect Plus 3 in 1 – VDW 950 1.3 lbs

$202.07

30-Day Refund Guarantee (Return Policy)
20+ Years of Experience

  • Water-based formula
  • Invisible
  • For natural stone and concrete pavers
  • Grouting relief for subsequent jointing with epoxy binder
  • Suitable for use on sensitive stones before jointing to reduce staining
  • Hydrophobic – water repellent
  • Oleophobic – oil-repellent
  • Solvent-free
SKU: GFTK950ESP Category: Brand:

The PHNA Xtreme Stone Protect 3-in-1 is a ready-to-use, water-based impregnation for the hydrophobic (water-repelling) and oleophobic (oil-repelling) treatment of natural stone and other porous paving units. This stone sealer can also be used as a pre-treatment before grouting with PHNA jointing compounds to reduce any residual binder film on sensitive paving surfaces.

The following are a few specific details about the product:

Water-Based Formula

Water-Based Formula

This Xtreme Protect allows for the same strength needed without the off-gassing that can occur with other products. It does not contain harmful chemicals, solvents, or VOCs that can harm the environment or pose a health risk to anyone exposed.

Invisible

Invisible

This allows you to be worry-free about your project, knowing it’s covered and sealed while allowing you to appreciate all the hard work put into its installation. This keeps the stone looking as natural as possible while offering maximum protection!

Water and Oil Repellent

Water and oil-repellent

Being Water and Oil-repellent allows for maximum protection while including ease and assessability in cleaning any spills that may occur. Hydrophobic (water-repelling) and oleophobic (oil-repelling) allow homeowners peace of mind living in any climate or any installation when using natural stone.

For Natural Stone and Concrete pavers

For Natural stone and concrete pavers

This treatment is an environmentally friendly choice for tile installations. It is made with eco-friendly materials that reduce its impact on the environment. Its water-based formula allows it to penetrate deep into the stone and protect it from the inside out! Especially for sensitive pavers.

Technical Data:

  • Application Temperature:
    • 10-26°C | 50-80°F Ambient and surface temp.
  • Full Effect:
    • After 24 hours at 20°C | 68°F and 65% rel. humidity
  • Density:
    • Approx. 1.0 g/l
  • Consumption:
    • Approx. 50 – 100 sq. ft. per liter | 250 – 500 sq. ft. per unit
    • (Highly dependent on the absorbency of the substrate, and in case of doubt, should be determined by applying a test area first)
  • Open to Pedestrian Traffic:
    • After 5 hours at 20°C | 68°F and 65% rel. humidity
  • Duration:
    • Approx. 2 years (dependent on the surface type, level of
    • product absorption and exposure)
  • PH Value:
    • Approx. 5
  • Storage Life:
    • 1 year if stored unopened in sealed and undamaged packaging.
      Must also be kept dry, cool, and frost-free

Application Instructions for Xtreme StoneProtect Plus 3 in 1 (VDW950)

1. Construction Site Requirements

  • A clean and dust-free, structurally sound, absorbent, and dry paved surface that is otherwise ready for jointing;
    • Or with jointing that is fully cured and has no residual resin binder on the surface.
  • Ambient and surface temperatures minimum 10 °C / 50 °F,
  • Maximum 26 °C / 80 °F, with dry weather conditions and no rain or heavy dew forecast for at least 24 hours.

2. Tools

  • Low-pressure sprayer, brushes, or rollers; sponges to remove any excess.
  • Suitable PPE should be used, including goggles, gloves, etc.

3. Application

  • The areas to be treated should be completely dry, clean, and free from any dirt or contaminants that could prevent or reduce penetration.
  • Apply the Xtreme Stone Protect 3-in-1 with a suitable low-pressure sprayer, brush,
    • Or roll evenly over the surface to saturation, avoiding any residual ponding or puddling.
  • Remove any excess with a sponge, particularly on surfaces with uneven absorbency.
    • Otherwise, localized darkening can occur.
  • Avoid splashes on adjacent materials and remove any spillages immediately with a damp cloth.

4. Curing

  • Protect area‘s treated with the Xtreme Stone Protect 3-in-1 from moisture and any other dirt or surface contamination for a minimum of 5 hours before access,
    • 24 hours before use (at 20 °C / 68 °F and 65 % relative humidity).
  • When completely dry, the treated paving can also be pointed with the appropriate PHNA jointing compound if this was not completed before the treatment.
Weight 1.3 lbs
Dimensions 9 × 12 × 5 in
Available Colors

Neutral, Stone Grey, Basalt

Begin Your Project journey at our showroom

Visit our 5,000 square feet indoor hardscape materials showroom in New Holland, PA where you will find hardscape layouts, outdoor kitchen ideas, patio paver designs, patio lighting features, and our high-quality patio furniture all on display. Find the colors and textures that best complement your style, and a guide to help you choose the best combinations for your hardscape project in New Holland, PA. Here you will find hundreds of hardscape materials on display along with a full display of backyard and patio ideas.